TEA1530AT 데이터 시트보기 (PDF) - Philips Electronics

부품명

상세내역

제조사

TEA1530AT

GreenChip™II SMPS control IC

Philips Electronics 

Philips Semiconductors

TEA1530AT

GreenChip™II SMPS control IC

7.5 Cycle skipping

At very low power levels, a cycle skipping mode activates. An internal control voltage

(Vsense(max)) lower than 25 mV will inhibit switch-on of the external power MOSFET until

this voltage increases to a higher value; see Figure 5.

7.6 Continuous Conduction Mode (CCM)

The IC operates in the so-called Fixed Frequency Continuous Conduction Mode (FF

CCM). Pin DRAIN should be connected to the rectified Vi voltage; see Figure 8.

7.7 OverCurrent Protection (OCP)

The primary peak-current in the transformer is measured accurately cycle-by-cycle using

the external sense resistor Rsense. The OCP circuit limits the voltage on pin “Sense” to an

internal level equal to 1.5V - Vctrl (also see section 7.3). The OCP detection is

suppressed during the leading edge blanking period tleb , to prevent false triggering

caused by the switch-on spikes.

7.8 Control pin protection

If pin CTRL becomes open-circuit or is disconnected, a fault condition is assumed and the

converter will stop switching immediately. Operation recommences when the fault

condition is removed.

7.9 Adjustable slope compensation

A slope compensation function has been added at pin CTRL; see Figure 6. The slope

compensation function prevents sub-harmonic oscillation in CCM at duty cycles over

50 %. The CTRL voltage is modulated by sourcing a (non-constant) current out of

pin CTRL and by adding externally a series resistor Rslopecomp. This increases the CTRL

voltage proportionally with the on-time, which therefore limits the OCP level. A longer

on-time results in a higher CTRL voltage, this increase in CTRL voltage will decrease the

on-time. Slope compensation can be adjusted by changing the value of Rslopecomp. Slope

compensation prevents modulation of the on-time (duty cycle) while operating in FF CCM.

A possible drawback of sub-harmonic oscillation can be output voltage ripple.

Objective data sheet

Rev. 01 — 18 May 2005

© Koninklijke Philips Electronics N.V. 2005. All rights reserved.

6 of 22

Share Link: