LXT970A 데이터 시트보기 (PDF) - Intel

부품명

상세내역

제조사

LXT970A

Dual-Speed Fast Ethernet Transceiver

Intel 

LXT970A — Dual-Speed Fast Ethernet Transceiver

2.4.2.1

Manual Configuration

The LXT970A can be manually configured to force operation in the following modes:

• 100FX, full-duplex

• 100FX, half-duplex

• 100TX, full-duplex

• 100TX, half-duplex

• 10T, full-duplex

• 10T, half-duplex

Refer to Table 12 through Table 14 in the Hardware Control Interface discussion for specific

manual configuration settings.

Figure 11. LXT970A Initialization Sequence

Power-up or Reset

2.4.2.2

MDIO Control

Mode

Low Check Value High

MDDIS

Manual Control

Mode

Read H/W Control

Interface

Initialize MDIO Registers

Pass Control to MDIO

Interface

Exit

Disable MDIO Writes

Read H/W Control

Interface

Update MDIO Registers

Auto-Negotiation/Parallel Detection

With auto-negotiation enabled at power-up or reset, the LXT970A attempts to establish link

operating conditions with its partner by sending Fast Link Pulse (FLP) bursts.

If the link partner is also capable of auto-negotiation, the two devices exchange FLP bursts to

communicate their capabilities to each other. Each side finds the highest common capabilities that

both sides can support and then begins operating in that mode.

If the link partner is not capable of auto-negotiation, it transmits either 10 Mbps Normal Link

Pulses (NLP) or 100 Mbps Idle symbols. When the LXT970A detects either NLPs or Idle symbols,

it automatically configures to match the detected operating speed in half-duplex mode. This ability

allows the LXT970A to communicate with devices that do not support auto-negotiation.

30

Datasheet

Share Link: