AT90S8515 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

제조사

AT90S8515

8-bit Microcontroller with 8K Bytes In-System Programmable Flash

Atmel Corporation 

External Reset

AT90S8515

An external reset is generated by a low level on the RESET pin. Reset pulses longer

than 50 ns will generate a reset, even if the clock is not running. Shorter pulses are not

guaranteed to generate a reset. When the applied signal reaches the Reset Threshold

Voltage (VRST) on its positive edge, the delay timer starts the MCU after the Time-out

period tTOUT has expired.

Figure 26. External Reset during Operation

Watchdog Reset

When the Watchdog times out, it will generate a short reset pulse of 1 XTAL cycle dura-

tion. On the falling edge of this pulse, the delay timer starts counting the Time-out period

tTOUT. Refer to page 42 for details on operation of the Watchdog.

Figure 27. Watchdog Reset during Operation

Interrupt Handling

0841G–09/01

The AT90S8515 has two 8-bit interrupt mask control registers; GIMSK (General Inter-

rupt Mask register) and TIMSK (Timer/Counter Interrupt Mask register).

When an interrupt occurs, the Global Interrupt Enable I-bit is cleared (zero) and all inter-

rupts are disabled. The user software can set (one) the I-bit to enable nested interrupts.

The I-bit is set (one) when a Return from Interrupt instruction (RETI) is executed.

For interrupts triggered by events that can remain static (e.g., the Output Compare

Register1 matching the value of Timer/Counter1), the interrupt flag is set when the event

occurs. If the interrupt flag is cleared and the interrupt condition persists, the flag will not

be set until the event occurs the next time.

When the Program Counter is vectored to the actual interrupt vector in order to execute

the interrupt handling routine, hardware clears the corresponding flag that generated the

25

Share Link: