PCA9502 데이터 시트보기 (PDF) - NXP Semiconductors.

부품명

상세내역

제조사

PCA9502

8-bit I/O expander with I2C-bus/SPI interface

NXP Semiconductors. 

NXP Semiconductors

PCA9502

8-bit I/O expander with I2C-bus/SPI interface

SDA

SCL

S

START

condition

0 to 6

address

7

8

R/W ACK

Fig 8. A complete data transfer

0 to 6

data

7

8

ACK

0 to 6

data

7

8

ACK

P

STOP

condition

002aab046

When an address is sent, each device in the system compares the first seven bits after the

START with its own address. If there is a match, the device will consider itself addressed

by the master, and will send an acknowledge. The device could also determine if in this

transaction it is assigned the role of a slave receiver or slave transmitter, depending on the

R/W bit.

Each node of the I2C-bus network has a unique seven-bit address. The address of a

microcontroller is of course fully programmable, while peripheral devices usually have

fixed and programmable address portions.

When the master is communicating with one device only, data transfers follow the format

of Figure 8, where the R/W bit could indicate either direction. After completing the transfer

and issuing a STOP condition, if a master would like to address some other device on the

network, it could start another transaction by issuing a new START.

Another way for a master to communicate with several different devices would be by using

a ‘repeated START’. After the last byte of the transaction was transferred, including its

acknowledge (or negative acknowledge), the master issues another START, followed by

address byte and data, without effecting a STOP. The master may communicate with a

number of different devices, combining ‘reads’ and ‘writes’. After the last transfer takes

place, the master issues a STOP and releases the bus. Possible data formats are

demonstrated in Figure 9. Note that the repeated START allows for both change of a slave

and a change of direction, without releasing the bus. We shall see later on that the change

of direction feature can come in handy even when dealing with a single device.

In a single master system, the repeated START mechanism may be more efficient than

terminating each transfer with a STOP and starting again. In a multimaster environment,

the determination of which format is more efficient could be more complicated, as when a

master is using repeated STARTs it occupies the bus for a long time and thus preventing

other devices from initiating transfers.

PCA9502_3

Product data sheet

Rev. 03 — 13 October 2006

© NXP B.V. 2006. All rights reserved.

9 of 25

Share Link: