DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

MSP34X5G 데이터 시트보기 (PDF) - Unspecified

부품명
상세내역
제조사
MSP34X5G Datasheet PDF : 98 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
MSP 34x5G
PRELIMINARY DATA SHEET
2.8. ADR Bus Interface
For the ASTRA Digital Radio System (ADR), the
MSP 3405G, MSP 3415G, and MSP 3455G performs
preprocessing such as carrier selection and filtering.
Via the 3-line ADR-bus, the resulting signals are trans-
ferred to the DRP 3510A coprocessor, where the
source decoding is performed. To be prepared for an
upgrade to ADR with an additional DRP board, the fol-
lowing lines of MSP 34x5G should be provided on a
feature connector:
I2S_DA_IN1 or I2S_DA_IN2
I2S_DA_OUT
I2S_WS
I2S_CL
ADR_CL, ADR_WS, ADR_DA
For more details, please refer to the DRP 3510A data
sheet.
2.10. Clock PLL Oscillator and
Crystal Specifications
The MSP 34x5G derives all internal system clocks
from the 18.432 MHz oscillator. In NICAM or in I2S-
Slave mode, the clock is phase-locked to the corre-
sponding source. Therefore, it is not possible to use
NICAM and I2S-Slave mode at the same time.
For proper performance, the MSP clock oscillator
requires a 18.432-MHz crystal. Note, that for the
phase-locked mode (NICAM, I2S slave), crystals with
tighter tolerance are required.
2.9. Digital Control I/O Pins and
Status Change Indication
The static level of the digital input/output pins
D_CTR_I/O_0/1 is switchable between HIGH and
LOW via the I2C-bus by means of the ACB register
(see page 34). This enables the controlling of external
hardware switches or other devices via I2C-bus.
The digital input/output pins can be set to high imped-
ance by means of the MODUS register (see page 23).
In this mode, the pins can be used as input. The cur-
rent state can be read out of the STATUS register (see
page 25).
Optionally, the pin D_CTR_I/O_1 can be used as an
interrupt request signal to the controller, indicating any
changes in the read register STATUS. This makes poll-
ing unnecessary; I2C-bus interactions are reduced to a
minimum (see STATUS register on page 25 and
MODUS register on page 23).
14
Micronas

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]