MT9300B 데이터 시트보기 (PDF) - Zarlink Semiconductor Inc
부품명
상세내역
제조사
MT9300B Datasheet PDF : 39 Pages
| |||
MT9300B
Data Sheet
In Back-to-Back configuration, writing a “1” into the MuteR bit of Echo Canceller A, Control Register 2, causes
quiet code to be transmitted on Rout. Writing a “1” into the MuteS bit of Echo Canceller A, Control Register 2,
causes quiet code to be transmitted on Sout.
In Extended Delay and in Back -to -Back configurations, MuteR and MuteS bits of Echo Canceller B must always
be “0”. Refer to Figure 4 and to Control Register 2 for bit description.
Bypass
The Bypass state directly transfers PCM codes from Rin to Rout and from Sin to Sout. When Bypass state is
selected, the Adaptive Filter coefficients are reset to zero. Bypass state must be selected for at least one frame
(125 µs) in order to properly clear the filter.
Disable Adaptation
When the Disable Adaptation state is selected, the Adaptive Filter coefficients are frozen at their current value. The
adaptation process is halted, however, the echo canceller continues to cancel echo.
Enable Adaptation
In Enable Adaptation state, the Adaptive Filter coefficients are continually updated. This allows the echo canceller
to model the echo return path characteristics in order to cancel echo. This is the normal operating state.
The echo canceller functions are selected in Control Register A1/B1 and Control Register 2 through four control
bits: MuteS, MuteR, Bypass and AdaptDis. Refer to the Registers Description for details.
MT9300B Throughput Delay
The throughput delay of the MT9300B varies according to the device configuration. For all device configurations,
Rin to Rout has a delay of two frames and Sin to Sout has a delay of three frames. In Bypass state, the Rin to Rout
and Sin to Sout paths have a delay of two frames.
Serial PCM I/O channels
There are two sets of TDM I/O streams, each with channels numbered from 0 to 31. One set of input streams is for
Receive (Rin) channels, and the other set of input streams is for Send (Sin) channels. Likewise, one set of output
streams is for Rout pcm channels, and the other set is for Sout channels. See Figure 7 for channel allocation.
The arrangement and connection of PCM channels to each echo canceller is a 2 port I/O configuration for each set
of PCM Send and Receive channels, as illustrated in Figure 4.
F0i
ST-Bus
F0i
GCI interface
Rin/Sin
Rout/Sout
Channel 0
Note: Refer to Figures 9 and 10 for timing details
125 µsec
Channel 1
Channel 30
Channel 31
Figure 7 - ST-BUS and GCI Interface Channel Assignment for 2 Mb/s Data Streams
14
Zarlink Semiconductor Inc.
Share Link: 