MT48H16M16LFF-8 데이터 시트보기 (PDF) - Micron Technology

부품명

상세내역

제조사

MT48H16M16LFF-8

256Mb: x16 MOBILE SDRAM

Micron Technology 

command is nonpersistent, so it must be issued each

time a refresh is required. All active banks must be

precharged prior to issuing an AUTO REFRESH com-

mand. The AUTO REFRESH command should not be

issued until the minimum tRP has been met after the

PRECHARGE command as shown in the operations sec-

tion.

The addressing is generated by the internal refresh

controller. This makes the address bits “Don’t Care”

during an AUTO REFRESH command. The 256Mb

SDRAM requires 8,192 AUTO REFRESH cycles every

64ms (tREF), regardless of width option. Providing a

distributed AUTO REFRESH command every 7.81µs

will meet the refresh requirement and ensure that each

row is refreshed. Alternatively, 8,192 AUTO REFRESH

commands can be issued in a burst at the minimum

cycle rate (tRC), once every 64ms.

SELF REFRESH

The SELF REFRESH command can be used to retain

data in the SDRAM, even if the rest of the system is

powered down. When in the self refresh mode, the

SDRAM retains data without external clocking.

ADVANCE

256Mb: x16

MOBILE SDRAM

The SELF REFRESH command is initiated like an AUTO

REFRESH command except CKE is disabled (LOW).

Once the SELF REFRESH command is registered, all

the inputs to the SDRAM become “Don’t Care” with

the exception of CKE, which must remain LOW.

Once self refresh mode is engaged, the SDRAM pro-

vides its own internal clocking, causing it to perform its

own AUTO REFRESH cycles. The SDRAM must remain

in self refresh mode for a minimum period equal to

tRAS and may remain in self refresh mode for an indefi-

nite period beyond that.

The procedure for exiting self refresh requires a se-

quence of commands. First, CLK must be stable (stable

clock is defined as a signal cycling within timing con-

straints specified for the clock pin) prior to CKE going

back HIGH. Once CKE is HIGH, the SDRAM must have

NOP commands issued (a minimum of two clocks) for

tXSR because time is required for the completion of any

internal refresh in progress.

Upon exiting the self refresh mode, AUTO REFRESH

commands must be issued every 7.81µs or less as both

SELF REFRESH and AUTO REFRESH utilize the row

refresh counter.

256Mb: x16 Mobile SDRAM

MobileRamY26L_A.p65 – Pub. 5/02

13

Micron Technology, Inc., reserves the right to change products or specifications without notice.

©2002, Micron Technology, Inc.

Share Link: